Go to the Project Navigator and double click on the CPU slot ( IC693CPU374). To Setup the GE 90/30 using the GE Cimplicity Programming Software, follow these steps: Using Proficy Machine Edition Method to see IP Address
Ge 90 30 programming manual manual#
Programming Software User Manual (included with P/N EZ-TOUCHEDIT, EZ-Touch Programming Software).
Poll Time (0-30000 msec): This is the amount of Time (in milliseconds) that the panel will wait in between each request. General Electric 90/30 and 90/70 15-pin D-SUB, RS-422A. After the Timeout timer expires, it will then retry. Timeout time (1-255) (in 100ms units): This is the amount of Time (in 100ms units) that the panel will wait on the Command reply (or TCP ACK message) after sending a request. This will occur on a TCP connect request or a Command request (after the TCP connection is established). Once the retry count (specified in this field) limit has been reached, the C-more panel will display a PLC Timeout error on the screen. If the CPU does not reply within the specified “ Response Timeout” period, the C-more panel will send the request again up to the number of Retries. Retries (0-10): The C-more panel will send a request to the GE Ethernet CPU. This field can also be changed if there is a requirement to have the SRTP server port number at a non-default value on a LAN. This field can be changed in the event that the C-more panel needs to access the PLC through a firewall using NAT. Redundant by design, these compact controllers use PROFINET for better performance and productivity, and are interoperable with most open industry standards. Port (0–65535): This is the SRTP server listening TCP port number of the PLC. Emerson’s Programmable Automation Controllers feature an extensive range to support scalable automation and minimize downtime. It can be found using the Proficy Machine Edition software (see below). 
IP Address: This is the IP Address of the GE Ethernet CPU. From the Panel Manager window click on the DEV001 selection on the tree to the left to open the Device Setup screen of the Panel Manager window shown below.įrom the PLC Protocol field, click on the down arrow and select the GE Ethernet SRTP (90/30 Rx3i) selection. The drop-down menu shown below opens.įrom the Setup drop-down menu, select the Panel Manager selection. To access the Panel Manager from the C-more Programming Software, from the Main Menu select Setup. The C-more panel is the master when communicating with a GE PLC. GE Ethernet 90/30 and Rx3i SRTP Protocol Setup GE-Fanuc-Series-90-30-PLC-Installation-and-Hardware-Manual: Downloads: GE-Series-90TM30-Programmable-Controller-Troubleshooting-Guide: Downloads: IC693PWR322 Manual: Downloads: datasheet-Series 90-30: Downloads: GE Intelligent Platforms - VersaMax PLC: Downloads: GE Intelligent Platforms - VersaMax PLC: Downloads: GE Intelligent Platforms.
0 kommentar(er)
